Error Code TE
Thermal Error — thermistor resistance output abnormal; wash temperature sensor failure
Moderate
Address soon - your appliance may not work properly
What This Means
Wiring connection disconnected (RD6 to WH4 connector); Thermistor damaged or out of resistance range
How to Fix
- 1
Check connector RD6~WH4 connection to main PCB; if disconnected, replace thermistor
- 2
Measure thermistor resistance — normal range is 8-44 kΩ; if out of range, replace thermistor
- 3
Measure voltage between RD6 pin3 and NA8 pin3 — should be 1-3V DC; if out of range, replace main PCB assembly
Other Error Codes for LDT7808WW
EEPROM Error — displayed during test mode step 1 if EEPROM fails self-check
Inlet Error — machine does not reach normal water level within fill timeout
Drain Error — machine does not drain down to normal level within drain timeout
Leakage Error — internal water leak detected by float/safety switch in base
Bubble Error — excessive sudsing detected; unit not leveled or wrong detergent
Excess Error — water fills above normal level; possible overfill due to stuck inlet valve or faulty sensor
Heater Error — water not heated or tub temperature overheated above 194°F; heater circuit fault
Motor Error — washing motor operating abnormally; motor RPM failure