Error Code AE
The dryer's internal parts aren't communicating properly
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: AE
What This Means
Faulty main PCB (control board); Faulty sub PCB (display board); Damaged or loose wire harness between main PCB and sub PCB; Damaged flat wire connecting main and sub PCBs
What actually causes this:
A loose wire connection between the control board and display, or a power surge scrambled the electronics.
First Thing to Check
Unplug the dryer for 2 minutes, then plug it back in — this resets the electronics.
Parts Involved
How to Fix
- 1
1. Check wire harness connection between main PCB and sub PCB for loose or damaged connectors
- 2
2. Inspect the flat wire between main and sub PCBs for damage
- 3
3. Check for pinched, cut, or corroded wires
- 4
4. If wiring is intact, replace sub PCB first (more commonly at fault)
- 5
5. If error persists after sub PCB replacement, replace main PCB
Other Error Codes for DV50K7500EW
The dryer thinks the door is open while running
A button on the control panel is stuck or shorted
The door switch isn't working properly
Your dryer is getting the wrong type of electrical power
Your dryer's temperature sensor isn't reading correctly
Your dryer is getting the wrong voltage from the outlet
Your dryer isn't heating properly or is overheating
The dryer's memory chip has a communication error