Error Code HC
Your dryer isn't heating properly or is overheating
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: HC
What This Means
Thermistor resistance out of range; Main PCB malfunction; Restricted vent system causing excessive heat buildup; Heater malfunction; Thermostat failure
What actually causes this:
Most often caused by a clogged exhaust vent that traps hot air inside the dryer, or the heating element has burned out.
First Thing to Check
Check your exhaust vent — disconnect it from the back of the dryer and look for lint buildup inside.
Parts Involved
How to Fix
- 1
1. Check the PCB and thermistor connections
- 2
2. Measure thermistor resistance: should be 10K ohm at 25 degrees C (77 degrees F)
- 3
3. Check thermostat resistance: should be < 1 ohm (infinity means replace)
- 4
4. Check heater resistance: SINGLE heater 10 ohm (PIN 1-3); DUAL heater 13 ohm (PIN 2-3) and 34 ohm (PIN 1-2)
- 5
5. Check exhaust vent system for restrictions or blockages
- 6
6. If resistance is infinity on heater, replace heater assembly
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for DVE45T3200
The dryer's internal parts aren't communicating properly
A secondary temperature sensor is giving bad readings
A button on the control panel is stuck or shorted
The door switch isn't working properly
Your dryer detected restricted airflow during a vent test
Your dryer is getting the wrong type of electrical power
Your dryer vent is about 80% blocked
The dryer thinks the door is open while running