Leaking water
Parts commonly needed when your Samsung dryer has this issue. Recommendations are based on repair patterns and may not diagnose your specific problem.
Verified Components
Parts
3Part numbers confirmed across multiple retailers for DVE45T3200
Repair tips for this issue
From the service manual for Samsung DVE45T3200 Series Dryers (2020)
From the service manual
Good to know
3 technician insights for the Samsung DVE45T3200 Series Dryers (2020)
Door reversal procedure — screw B is longer
When performing door reversal, 10 screws are removed from the door assembly. Screw B (2 screws) is longer than the other 8 screws. If the long screws are installed in the wrong positions during reassembly, they can damage internal components or the door may not seat properly. Always note screw positions during disassembly.
Moisture sensor validation after reassembly
After reassembling the moisture sensor or any components near it (Case Filter, Duct Outlet, etc.), you must verify the touch sensor works properly through Smart Install test mode. Enter Smart Install, open the door, place a wet cloth on the sensor (should show 1), remove cloth (should show 0). Failure to verify can lead to inaccurate sensor dry cycles.
Door switch insert direction — critical during reassembly
When reassembling the door switch to the Frame Front, the insert direction is critical. Installing the door switch in the wrong orientation will cause it to malfunction and may trigger dC or dF error codes. The manual specifically warns to check that the Frame Front is fixed on the Frame well and that the Door-Switch works properly after reassembly.
Seeing an error code on your display? Look up your error code → for more specific diagnostic information.