Won't spin or agitate
Parts commonly needed when your Samsung dryer has this issue. Recommendations are based on repair patterns and may not diagnose your specific problem.
Verified Components
Parts
2Part numbers confirmed across multiple retailers for DVE52M8650V
Repair tips for this issue
From the service manual for Samsung DVE52M8650 Series Dryers
From the service manual
Good to know
5 technician insights for the Samsung DVE52M8650 Series Dryers
Smart Install mode for verifying installation
After installing the dryer, use Smart Install mode to verify everything works: Press Adjust Time + Temp for 7 seconds. Display shows 'SC'. It tests the moisture sensor (touch sensor) and the motor/heater in two steps. If both pass, display shows 'OK'. If motor or heater fails, display shows 'HC'. This is faster than running a full cycle to verify installation.
Blower fan imbalance from debris causes noise
Noise from the motor area can be caused by debris (alien particles) stuck on the blower fan wings, creating an imbalance. Remove any particles from the fan and check that the fan nut is properly tightened (14mm socket). This is a different problem from blower housing rubbing and does not require fan replacement if the fan itself is undamaged.
Belt positioning during reassembly
When reassembling the drum belt, it must be located between the 2 red arrows marked on the drum. Incorrect belt positioning can cause belt slipping, improper tumbler speed, and uneven wear that leads to premature failure.
Smart Install mode displays 'SC' not 'AS' on DV8700M/DV8600M models
On these DV8700M/DV8600M models, Smart Install mode displays 'SC' on entry (not 'AS' as seen on some other Samsung dryer models). Press Adjust Time Up + Temp for 7 seconds to enter. Step 1 tests touch sensor (0=open, 1=wet). Step 2 tests motor/heater (OK or HC). This is faster than running a full cycle to verify installation.
Seeing an error code on your display? Look up your error code → for more specific diagnostic information.