Error Code HC
Your dryer isn't heating properly or is overheating
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: HC
What This Means
Faulty PCB; Faulty thermistor; Restricted vent system causing excessive heat buildup; Heater malfunction; Thermostat failure
What actually causes this:
Most often caused by a clogged exhaust vent that traps hot air inside the dryer, or the heating element has burned out.
First Thing to Check
Check your exhaust vent — disconnect it from the back of the dryer and look for lint buildup inside.
Parts Involved
How to Fix
- 1
1. Check the PCB and thermistor
- 2
2. Check exhaust vent system for restrictions or blockages
- 3
3. Measure thermistor resistance: should be 10K ohm at 25 deg C (77 deg F)
- 4
4. Check thermostat resistance: should be < 1 ohm (infinity means replace)
- 5
5. Check heater resistance values per component testing section
- 6
6. For gas models, check gas valve, igniter, and flame sensor
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for DVE53BB8700V
The dryer thinks the door is open while running
Your dryer's temperature sensor isn't reading correctly
The door switch isn't working properly
The dryer's internal parts aren't communicating properly
Your dryer is getting the wrong type of electrical power
Your dryer is getting the wrong voltage from the outlet
A button on the control panel is stuck or shorted
A secondary temperature sensor is giving bad readings