How do I fix error code IE on a LG washers?

1. undefined: Confirm IE is displayed on screen 2. undefined: Press WASH/RINSE and DELAY WASH buttons simultaneously to check water level frequency — is it below 24.6 kHz? If yes, check air chamber and tube for clogging 3. undefined: Inspect inlet valve filter — if clogged with foreign material, clean or replace the filter 4. undefined: Check if inlet valve connectors are broken or loose — if yes, reconnect or repair the connector 5. undefined: Measure resistance between each terminal of INLET VALVE ASSEMBLY: expected 0.8-1.2 kΩ (pins 1-2). If out of range, replace INLET VALVE ASSEMBLY 6. undefined: Check voltage of inlet valve connector — is it 120V DC? If yes, replace INLET VALVE ASSEMBLY 7. undefined: Check connector at MAIN PWB assembly (NA4, BL6, RD6) — if disconnected, reconnect or repair 8. undefined: Verify electrical connection against wiring diagram — if incorrect, replace MAIN HARNESS 9. undefined: After verifying connector, recheck water level frequency — if still below 24.6 kHz, check PRESSURE SWITCH 10. undefined: If none of the above resolves, replace MAIN PWB ASSEMBLY 11. undefined: Installation safety check: verify no water tap leakage, no frozen pipes, no tangled supply hose, adequate water supply, no hose shrinkage from hot/cold misuse

LG Washers2022–present

Error Code IE

Q: What does error code IE mean on a LG washers?

Water Inlet Error Correct water level (24.6 kHz) not reached within 8 minutes after water is supplied; Water does not reach preset level within 20 minutes; Inlet valve filter clogged with foreign material; Inlet valve connectors broken or loose; Resistance of inlet valve assembly outside 0.8-1.2 kΩ range; Air chamber or tube clogged; Connector disconnected at MAIN PWB assembly (NA4, BL6, RD6); Electrical wiring fault in main harness; Pressure switch defective

Water Inlet Error

Moderate

Address soon - your appliance may not work properly

What This Means

Correct water level (24.6 kHz) not reached within 8 minutes after water is supplied; Water does not reach preset level within 20 minutes; Inlet valve filter clogged with foreign material; Inlet valve connectors broken or loose; Resistance of inlet valve assembly outside 0.8-1.2 kΩ range; Air chamber or tube clogged; Connector disconnected at MAIN PWB assembly (NA4, BL6, RD6); Electrical wiring fault in main harness; Pressure switch defective

How to Fix

1
Confirm IE is displayed on screen
2
Press WASH/RINSE and DELAY WASH buttons simultaneously to check water level frequency — is it below 24.6 kHz? If yes, check air chamber and tube for clogging
3
Inspect inlet valve filter — if clogged with foreign material, clean or replace the filter
4
Check if inlet valve connectors are broken or loose — if yes, reconnect or repair the connector
5
Measure resistance between each terminal of INLET VALVE ASSEMBLY: expected 0.8-1.2 kΩ (pins 1-2). If out of range, replace INLET VALVE ASSEMBLY
6
Check voltage of inlet valve connector — is it 120V DC? If yes, replace INLET VALVE ASSEMBLY
7
Check connector at MAIN PWB assembly (NA4, BL6, RD6) — if disconnected, reconnect or repair
8
Verify electrical connection against wiring diagram — if incorrect, replace MAIN HARNESS
9
After verifying connector, recheck water level frequency — if still below 24.6 kHz, check PRESSURE SWITCH
10
If none of the above resolves, replace MAIN PWB ASSEMBLY
11
Installation safety check: verify no water tap leakage, no frozen pipes, no tangled supply hose, adequate water supply, no hose shrinkage from hot/cold misuse