Error Code HC
Your dryer isn't heating properly or is overheating
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: HC (Upper and Lower)
What This Means
Restricted vent system causing excessive heat buildup; Clogged lint filter; Thermistor resistance out of range; Heater malfunction; PCB fault
What actually causes this:
Most often caused by a clogged exhaust vent that traps hot air inside the dryer, or the heating element has burned out.
First Thing to Check
Check your exhaust vent — disconnect it from the back of the dryer and look for lint buildup inside.
Parts Involved
How to Fix
- 1
1. Clean the lint filter
- 2
2. Check the PCB and Thermistor
- 3
3. Check exhaust vent system for restrictions or blockages
- 4
4. Measure thermistor resistance: should be 10KΩ at 25°C (77°F) for lower, 238.23KΩ at 25°C for upper
- 5
5. Check thermostat resistance: should be < 1Ω (infinity means replace)
- 6
6. Check heater resistance: DUAL heater — 13Ω between PIN 2-3, 34Ω between PIN 1-2; SINGLE heater — 10Ω between PIN 1-3
- 7
7. If resistance is infinity on heater, replace heater assembly
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung DVE60A9900 Series Dryers
Related Error Codes
Your dryer is getting the wrong voltage from the outlet
A secondary temperature sensor is giving bad readings
Your dryer is getting the wrong type of electrical power
Your dryer's temperature sensor isn't reading correctly
The dryer's internal parts aren't communicating properly
The dryer thinks the door is open while running
The door switch isn't working properly