Error Code HE
Your dryer isn't heating properly or is overheating
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: HE
What This Means
Restricted vent system causing excessive heat buildup; Thermistor resistance out of range; Heater malfunction; Thermostat failure
What actually causes this:
Most often caused by a clogged exhaust vent that traps hot air inside the dryer, or the heating element has burned out.
First Thing to Check
Check your exhaust vent — disconnect it from the back of the dryer and look for lint buildup inside.
Parts Involved
How to Fix
- 1
1. Check exhaust vent system for restrictions or blockages
- 2
2. Measure thermistor resistance: Cycling Thermistor1 should be 10KOhm at 25C; Cycling Thermistor2 should be 238.231KOhm at 25C
- 3
3. Check thermostat resistance: should be < 1Ohm (infinity means replace)
- 4
4. Check heater resistance: DUAL heater - 13Ohm between PIN 2-3, 34Ohm between PIN 1-2; SINGLE heater - 10Ohm between PIN 1-3
- 5
5. Call customer service if issue persists
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung DVE60M9900 Series Dryers (2024) (2024–present)
Related Error Codes
The dryer thinks the door is open while running
The dryer's internal parts aren't communicating properly
The dryer's memory chip has a communication error
The door switch isn't working properly
A button on the control panel is stuck or shorted
Your dryer is getting the wrong voltage from the outlet
Your dryer's temperature sensor isn't reading correctly
Your dryer is getting the wrong type of electrical power