How do I fix error code dC on a Samsung washers?

1. undefined: 1. Check the Reed Switch resistance — normal: approximately 0.2 Ohm between terminals (Checking Part: White-Green Wire) 2. undefined: 2. Check if the error occurs during the boiling course — as this error occurs because the door is opened, close the door 3. undefined: 3. Since 120V power is connected, check if the door switch is defective, or the power cord is disconnected — check and repair the insulation status if necessary 4. undefined: 4. Check the door lock/unlock motor resistance — normal: 33 Ohm to 46 Ohm between terminals (Checking Part: Black-Brown Wire) 5. undefined: 5. If the main PBA door detection circuit is defective, replace it

Samsung Washers2024–present

Error Code dC

Q: What does error code dC mean on a Samsung washers?

The washer does not detect that the lid is properly closed Switch contact error due to deformation of the door hook; Door was pulled open by force during a cycle; Pressure difference from internal temperature changes during Boil wash pushes the door open; Door switch is defective; Main PCB fault; Power cord is disconnected

The washer does not detect that the lid is properly closed

Moderate

Address soon - your appliance may not work properly

Also displayed as: dC

What This Means

Switch contact error due to deformation of the door hook; Door was pulled open by force during a cycle; Pressure difference from internal temperature changes during Boil wash pushes the door open; Door switch is defective; Main PCB fault; Power cord is disconnected

What actually causes this:

The lid is not fully closed, or the lid lock mechanism is worn out

First Thing to Check

Open the lid completely and close it firmly until you hear it click — make sure nothing is in the way

Parts Involved

Door SwitchReed SwitchDoor HookMain PBADoor Lock Motor

How to Fix

1
1. Check the Reed Switch resistance — normal: approximately 0.2 Ohm between terminals (Checking Part: White-Green Wire)
2
2. Check if the error occurs during the boiling course — as this error occurs because the door is opened, close the door
3
3. Since 120V power is connected, check if the door switch is defective, or the power cord is disconnected — check and repair the insulation status if necessary
4
4. Check the door lock/unlock motor resistance — normal: 33 Ohm to 46 Ohm between terminals (Checking Part: Black-Brown Wire)
5
5. If the main PBA door detection circuit is defective, replace it