Error Code tE1
The water temperature sensor is not reading correctly
Moderate
Address soon - your appliance may not work properly
Also displayed as: tE1
What This Means
Washing heater sensor in the tub has a contact error; Temperature sensor fault; Connector is connected incorrectly or is disconnected; Wire disconnected or has a contact error; Water level sensor operates without water due to freezing; Temperature sensor detects 100-150 degrees C triggering safety shutdown
What actually causes this:
The temperature sensor wire came loose or the sensor itself has gone bad
First Thing to Check
Turn off the washer, wait 30 seconds, and restart — if the error persists, it needs service
Parts Involved
How to Fix
- 1
1. Check the temperature sensor connector — ensure it is connected correctly and not disconnected
- 2
2. Check for wire disconnection or contact errors at the connector
- 3
3. Check if water is frozen, causing the water level sensor to operate without water
- 4
4. Verify the temperature sensor is reading correctly and not detecting 100-150 degrees C
- 5
5. Replace the temperature sensor if faulty
This Error Applies To
Samsung WA45H7000A Series Washers (2024) (2024–present)
Related Error Codes
The washer cannot detect the correct water level inside the tub
The washer's motor cannot spin properly
The washer's vibration sensor has a data reading error
The washer's WiFi module has lost connection to the main board
The washer's display module has lost connection to the main board
The washer's main computer has malfunctioned
The washer's main computer has malfunctioned
The washer's main computer has malfunctioned