Error Code BC2
A button on the control panel is stuck or pressed in
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Switch jammed or stuck due to uneven pressing from control panel deformation; Screws holding the sub PBA tightened too much; Button other than Power button continuously pressed for more than 30 seconds; Deformation of an internal plastic injection part; Sub PBA assembly screw over-tightened
What actually causes this:
A button on the front panel got stuck, possibly from a spill or moisture buildup
First Thing to Check
Press each button on the control panel to see if any feel stuck — gently wiggle them free
Parts Involved
How to Fix
- 1
1. Check for any stuck or jammed buttons on the control panel
- 2
2. Check if the control panel is warped or deformed
- 3
3. Inspect sub PBA mounting screws — loosen if over-tightened
- 4
4. Check for deformed internal plastic injection parts
- 5
5. Replace the sub PBA or control panel if damaged
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WF45A6400A Series Washers (2024) (2024–present)
Related Error Codes
The washer thinks the door is open
The door lock mechanism is not engaging properly
The small add-door on the front of the washer is open
The small add-door lock motor is not working correctly
The water heater inside the washer is not working right or the washer is overheating
The washer overheated and shut itself off for safety
The washer is filling with too much water and cannot stop
The washer is not filling with water