Error Code C-d1
The door lock is misaligned.
Moderate
Address soon - your appliance may not work properly
What This Means
Door latch not properly aligned; Lock motor resistance out of spec; Wiring harness disconnected from lock motor
How to Fix
- 1
Disconnect power
- 2
Disconnect harness from lock motor
- 3
Check door lock switch (COM-NO)
- 4
Measure lock motor coil resistance (should be 1750-1850 ohms)
- 5
Check wire harness connection to CN300 on main PCB
- 6
Verify 120V AC is applied to lock motor when activated
- 7
Replace lock motor or main PCB if needed
Other Error Codes for NE63T8751SG
There is a short in the control key.
Communication between Main and Touch is interrupted.
The sub PCB temperature rises abnormally high.
The oven sensor is open when the oven is operating. There is a short in the oven sensor.
The internal temperature rises abnormally high.
Communication between Main and Sub PCB is interrupted.
The PCB temperature rises abnormally high.
This code appears if the divider is inserted or removed while the oven is operating.