Error Code C-d1
Door locking mechanism error — door lock motor or switch malfunction
Moderate
Address soon - your appliance may not work properly
What This Means
Harness not connected properly to door lock switch motor; Abnormal door lock motor coil resistance (normal: 1750-1850 ohms); No AC 120V voltage supplied to lock motor; Faulty door lock micro switch; Faulty main PCB connector CNS300
How to Fix
- 1
Disconnect power and open back cover
- 2
Check harness connection to door lock motor
- 3
Check microswitch (COM to NO: infinite ohms at room temperature)
- 4
Measure lock motor coil resistance (normal: 1750-1850 ohms at room temperature)
- 5
Check harness connection at CNS300 on main PCB
- 6
Measure resistance at CNS300 (COM-NO: infinite ohms at room temperature; COM is orange, NO is orange)
- 7
Apply AC 120V to lock motor and verify operation
- 8
Replace micro switch or lock motor if faulty
- 9
Repair or replace damaged harness
- 10
Replace main PCB if connector or board is faulty
Other Error Codes for NX58M6650WS
Main PCB to Touch module communication error
Oven overheating — oven temperature exceeds 650°F (343°C) in any cooking function except self-clean
PCB ambient temperature too high — temperature around PCB is excessive
Shorted keypad key detected
Oven temperature sensor open (resistance over 2950 ohms) or shorted (resistance under 930 ohms)
PCB internal sensor opened (over 3900 ohms) or shorted