Error Code BC2
A control panel button appears to be stuck
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Power button is continually pressed; A button other than Power is continually pressed; No gap between control panel button and corresponding micro switch; PBA holding screws fastened too tight; Main PBA switching IC fault; Main relay connections incorrect
What actually causes this:
One of the buttons on the control panel is stuck down, or the screws holding the circuit board are too tight
First Thing to Check
Press each button on the control panel firmly to make sure none are stuck
Parts Involved
How to Fix
- 1
1. Check whether the Power switch or a contact switch is continually pressed
- 2
2. Check the contact between control panel buttons and their corresponding contact switch — there must be a gap between a button and its micro switch
- 3
3. Check whether the service PBA holding screws are fastened too tight — if so, loosen them a little
- 4
4. If the main PBA switching IC on/off check has occurred, replace the main PBA
- 5
5. If the E2 check occurs, the main relay connections are incorrect — check connections and replace Main PBA if needed
Other Error Codes for WA45T3200AW
The washer added an extra rinse because the load was uneven
The water inside the washer is dangerously hot
The washer cannot detect where the clutch is positioned
The vibration sensor board is not working
The vibration sensor board is not working
The water level sensor cannot detect the water level
The washer's motor is not spinning properly
The power supply voltage is too high