Error Code BC2
A button on the control panel is stuck or being held down.
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Power button pressed continually for more than 12 seconds; A switch is jammed or stuck due to uneven pressing from deformation of control panel or button; Sub PBA screws tightened too much, pressing on switch contacts; A button other than Power is pressed continually for more than 30 seconds; Deformation of internal plastic injection part; Main PBA IC switching on/off has occurred continuously
What actually causes this:
A button on the control panel is physically stuck, often from spilled detergent or over-tightened screws during a previous repair.
First Thing to Check
Press each button on the control panel to make sure none are sticking. Wipe around all buttons with a damp cloth to remove any residue.
Parts Involved
How to Fix
- 1
1. Check whether the Power switch or either a defect of the main PCB is continually pressed
- 2
2. Check the contact between the control panel buttons and their corresponding tact switch
- 3
3. Check whether the service PBA holding screws are fastened too tight — if so, loosen them a little
- 4
4. There must be a gap between a control panel button and its corresponding micro switch
- 5
5. If the main PBA main relay has occurred, an 'E2' check occurs. Otherwise, a check occurs after approx. 30 seconds
- 6
6. Check the connections — if there is no check in the passed connections, replace the main PBA
Other Error Codes for WA50K8600AV
The washer's WiFi module lost communication with the main board.
The washer's temperature sensor is giving wrong readings.
A specific internal water leak has been found.
There are too many soap suds in the washer.
The washer's vibration sensor board has a problem.
The washer's clutch position sensor is sending incorrect signals.
The washer's main computer chip has crashed.
The washer's display module lost communication with the main board.