Error Code 9C2
The washer is getting too much electrical power.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 9C2
What This Means
Over voltage being supplied to the washer; Main PBA fault (sometimes)
What actually causes this:
Your home's electrical supply is delivering higher-than-normal voltage, possibly from a utility issue.
First Thing to Check
Unplug the washer, wait 30 seconds, and plug it back in. If the error returns, the issue may be with your home's electrical supply.
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions and operating voltage
- 2
2. Connect a tester to the internal power terminals and observe operation
- 3
3. Check whether a plug receptacle is used
- 4
4. If main PBA fault, replace PBA
Other Error Codes for WA50K8600AW
The washer's temperature sensor is giving wrong readings.
A specific internal water leak has been found.
There are too many soap suds in the washer.
The washer's vibration sensor board has a problem.
The washer's clutch position sensor is sending incorrect signals.
The washer's main computer chip has crashed.
The washer cannot detect how much water is in the tub.
The washer's motor cannot spin or is getting bad signals.