Error Code 9C1
The washer is not getting enough electrical power.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 9C1
What This Means
Under voltage being supplied to the washer; Plug receptacle (extension cord) being used causing voltage drop; Connecting wire length of 1m may cause momentary low voltage drop up to 10V; Main PBA fault (sometimes)
What actually causes this:
The washer is plugged into an extension cord or a shared outlet that drops voltage when other appliances run.
First Thing to Check
Make sure the washer is plugged directly into a wall outlet — not into an extension cord or power strip.
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions
- 2
2. Make sure to check the operating voltage
- 3
3. Connect a tester to the internal power terminals during the Boil or Dry operations and observe the machine's operation carefully
- 4
4. Check the voltages
- 5
5. Check whether a plug receptacle (extension cord) is used
- 6
6. If main PBA fault, replace PBA
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for WA52J8060AW
The washer's temperature sensor is giving wrong readings.
A specific internal water leak has been found.
There are too many soap suds in the washer.
The washer's vibration sensor board has a problem.
The washer's clutch position sensor is sending incorrect signals.
The washer's main computer chip has crashed.
The washer cannot detect how much water is in the tub.
The washer's motor cannot spin or is getting bad signals.