Error Code 9C2
Your washer is getting too much electrical power
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: 9C2
What This Means
Over voltage power supply to the washer; Unstable power supply in the home; Main PBA fault (sometimes)
What actually causes this:
The voltage from the wall outlet is higher than normal, which can happen during power surges
First Thing to Check
Unplug the washer during a storm or power fluctuation and wait for power to stabilize
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions and verify operating voltage
- 2
2. Connect a tester to the internal power terminals during the Sanitize Cycle and observe operation
- 3
3. Check the voltage at the outlet — it should be approximately 120V
- 4
4. If voltage is consistently high, recommend electrician evaluation
- 5
5. If power is verified normal, replace Main PBA
Other Error Codes for WF25A8900AV
The washer's main computer chip has failed
The washer's motor can't spin properly
Your washer isn't getting enough electrical power
The washer's display screen lost its connection to the main board
An internal communication module lost its connection
The washer's Wi-Fi module lost its connection to the main board
The washer door isn't closing or locking properly
The water heater inside the washer isn't working right