Error Code 4C2
The incoming water is too hot for delicate cycles
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4C2
What This Means
Hot water supply temperature exceeds 50 degrees C; Cold and warm water supply hoses are wrongly engaged (swapped); Temperature sensor fault
What actually causes this:
The hot and cold water hoses are connected to the wrong inlets, so hot water is going where cold water should
First Thing to Check
Check if the hot and cold water hoses behind the washer are connected to the correct faucets
Parts Involved
How to Fix
- 1
1. Check that hot and cold water hoses are connected to the correct inlets
- 2
2. Verify that the home water heater temperature setting is appropriate
- 3
3. Run the Wool or Lingerie cycle and check if the error recurs after correcting hose connections
Other Error Codes for WF45M5500AZ
The vibration sensor detected a problem with its own readings
The washer's main computer has malfunctioned
Your washer is getting too much electrical power
The washer's door lock has a wiring or switch problem
The WiFi module lost its connection to the main board
Your washer can't tell how much water is inside
The washer's motor isn't spinning correctly
Your washer can't pump the water out