Error Code 4C
Your washer is not getting enough water to start or continue the cycle.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4C
What This Means
Foreign material entering the water supply valve; Water supply valve terminal not connected or wire disconnected; Warm water and rinse connectors are wrongly connected to each other; PCB terminal from drain hose to detergent drawer not connected; Transparent hose is folded or torn
What actually causes this:
Usually the water faucets behind the washer are not fully turned on, or the inlet hose screens are clogged with sediment.
First Thing to Check
Make sure both hot and cold water faucets behind the washer are fully turned on.
Parts Involved
How to Fix
- 1
1. Verify that water supply faucets are fully open
- 2
2. Check for foreign material in the water supply valve inlet screens
- 3
3. Inspect the water supply valve wire terminal connections
- 4
4. Verify warm water and rinse connectors are connected to the correct ports
- 5
5. Confirm the transparent hose from drain to detergent drawer is not folded or torn
- 6
6. Check PCB terminal connections
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for WF45N5300AF
The small add-door on the front of your washer is not properly closed or locked.
Your washer has detected a water leak inside the machine.
Your washer's vibration sensor has a general fault.
Your washer's main computer board has crashed and cannot recover.
An internal communication module in your washer has lost its connection.
Your washer's door lock mechanism has a hardware fault.
Your washer's motor controller has lost communication with the main board.
Your washer is not getting enough electrical power to run properly.