Error Code CC
The water inside is too hot to drain safely.
Moderate
Address soon - your appliance may not work properly
Also displayed as: CC
What This Means
Washing water temperature is 55C or greater when drain is requested; Temperature sensor fault or incorrect use; Hot water drainage could cause burns on contact
What actually causes this:
This is a normal safety feature — the washer pauses draining because the water is very hot. It will resume automatically once the water cools down.
First Thing to Check
Wait 15 to 20 minutes for the water to cool down. The washer should resume draining on its own.
Parts Involved
How to Fix
- 1
1. Check the washing temperature sensor
- 2
2. Check the resistance on both terminals of the heater: 25.19 to 27.84 Ohm
- 3
3. Check voltage on both terminals of heater while washing
- 4
4. If water temperature is normal but error persists, temperature sensor is faulty — replace washing heater
- 5
5. When replacing heater, take care to prevent water leakage
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for WW22N6850QX
The main computer and motor driver boards are not communicating.
The main board and motor inverter have lost communication.
The washer cannot detect the water level correctly.
The washing machine motor is not spinning properly.
The motor is drawing too much power or not reaching the right speed.
The washer cannot pump the water out.
The control panel and the main computer board are not communicating.
The washer's WiFi module is not communicating with the main board.