Error Code IE
Water Supply Error — water level does not rise to set level within 30 minutes; NO INLET lamp blinks
Moderate
Address soon - your appliance may not work properly
What This Means
Water faucet is closed; Water supply is interrupted; Inlet valve is clogged with debris; Connector has bad contact to the inlet valve; RED 6-pin connector (RD6) has a bad connection at the main board
How to Fix
- 1
Open water faucet and wait until water supply is resumed
- 2
Clean or replace the inlet valve filter screen
- 3
Check and correct the RD6 connector contact at the main board
- 4
Inspect inlet valve solenoid resistance — should be 24 ohms +/-10%; replace if out of range
- 5
In service mode (step 3-7), verify each inlet valve solenoid activates and water flows
This Error Applies To
LG WT1501CW Series Washers
Related Error Codes
Pressure Sensor Error — pressure switch has a bad connection or has failed
Motor Error (Locked Motor) — hall sensor or stator/rotor fault
Lid Lock Error — lid lock failed to engage or disengage
Drainage Error — water is not completely drained within 12 minutes
Unbalance Error — laundry unbalance detected during spin
Lid Open Error — lid is opened during intermittent spin, normal spin, or while processing a reservation/delay
Thermistor Error — thermistor has a bad connection or has failed
AC Motor / Clutch Motor Error — AC motor bad connection or failed; clutch failure