Error Code 9e1
Your dryer is getting the wrong voltage from the outlet
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: 9e1
What This Means
Abnormal power supply voltage; Faulty PCB voltage sensing circuit; Damaged wire harness
What actually causes this:
The electrical outlet isn't providing the right power — could be a tripped breaker, loose plug, or wiring issue.
First Thing to Check
Check your electrical panel and make sure the dryer's breaker hasn't tripped — flip it fully off then back on.
Parts Involved
How to Fix
- 1
1. Measure voltage at the outlet: Electric should be 240V, Gas should be 120V
- 2
2. Check PCB and wire harness for damage
- 3
3. Check power supply for voltage stability
- 4
4. Replace PCB if voltage is correct but error persists
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung DV45H7000E Series Dryers (2014) (2014–present)
Related Error Codes
The door switch isn't working properly
The dryer's memory chip has a communication error
The dryer thinks the door is open while running
The dryer's internal parts aren't communicating properly
Your dryer isn't heating properly or is overheating
Your dryer is getting the wrong type of electrical power
Your dryer's temperature sensor isn't reading correctly
A button on the control panel is stuck or shorted