Error Code dF
The door switch isn't working properly
Moderate
Address soon - your appliance may not work properly
Also displayed as: dF
What This Means
Loose wire terminals in door sense circuit; Open wire terminals in door sense circuit; Defective door switch giving invalid readings; Door sensor unit shorted
What actually causes this:
The switch that detects whether the door is open or closed has worn out or its connection came loose.
First Thing to Check
Open the door, check for anything stuck in the door latch area, then close it firmly and try again.
Parts Involved
How to Fix
- 1
1. Check if the door sensor unit is loose or short
- 2
2. Test door switch: Door open (Off) -- COM-NC (pins 1-3) should be < 1 ohm, COM-NO (pins 1-2) should be infinity
- 3
3. Test door switch: Door closed (On) -- COM-NC (pins 1-3) should be infinity, COM-NO (pins 1-2) should be < 1 ohm
- 4
4. If switch readings are inconsistent, replace door switch
This Error Applies To
Samsung DVE45T6020 Series Dryers (2020) (2020–present)
Related Error Codes
Your dryer is getting the wrong type of electrical power
Your dryer's temperature sensor isn't reading correctly
A secondary temperature sensor is giving bad readings
The dryer thinks the door is open while running
A button on the control panel is stuck or shorted
Your dryer is getting the wrong voltage from the outlet
Your dryer isn't heating properly or is overheating
The dryer's internal parts aren't communicating properly