Error Code C-F2
Loss of communication between main control and touch display panel
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: C-F2
What This Means
Touch PCB connector not fully inserted; Sub PCB connector failure; Wire harness damage; Control PCB internal failure
What actually causes this:
Loose touch connector, corroded pins, or Sub PCB failure
First Thing to Check
Check touch panel ribbon cable connection to Sub PCB (CN501)
Parts Involved
How to Fix
- 1
Check Sub PCB connector insertion
- 2
Verify wire harness connection to touch panel
- 3
Test Sub PCB functionality
This Error Applies To
Samsung DOC30P977D Series Ovens & Ranges
Related Error Codes
Broil heating element not energizing during self-test
Partition configuration changed during active cooking cycle
Cooling motor not responding to control signals
Drain system unable to evacuate water within time limit
Loss of communication between main control board and sub control board
Temperature sensor circuit is open - no resistance reading possible
Main control board temperature sensor reads excessive heat
Gas sensor output voltage out of acceptable operating range