Error Code Cd2
Door lock is mispositioned — door lock motor or switch fault during self-clean
Moderate
Address soon - your appliance may not work properly
What This Means
Harness not connected with door lock switch and motor; Door lock motor resistance out of spec (normal: 8~15 ohms at room temperature); Door locking switch not working normally
How to Fix
- 1
Disconnect power, open the cover back
- 2
Check whether harness has been connected with door lock switch and motor
- 3
Confirm whether resistance value of door lock motor is correct — normal value: 8~15 ohms at room temperature
- 4
Operate door lock, measure voltage at plug supplying power to door lock motor — normal voltage: AC 120V
- 5
Check whether door locking switch is working normally
This Error Applies To
Samsung NE Series Ovens & Ranges
Related Error Codes
Oven sensor is open when the oven is operating
Communication between Main PCB and Touch PCB is interrupted
Internal temperature rises abnormally high — safety error
Communication between Main PCB and Sub PCB is interrupted
Key short circuit — keypad short detected on Sub PCB
PCB temp sensor is short when oven is operating
PCB temperature rises abnormally high
PCB temp sensor is open when oven is operating