Error Code 8E
An internal sensor board has stopped working
Moderate
Address soon - your appliance may not work properly
Also displayed as: Hot&Cool LED flash
What This Means
MEMS PBA defective; Wire connections disconnected; Main PBA wire disconnection code; PBA silver nano part malfunction
What actually causes this:
The vibration sensor board inside the washer has malfunctioned
First Thing to Check
Unplug the washer for a few minutes and try again
Parts Involved
How to Fix
- 1
1. Check wire connections
- 2
2. Replace the MEMS PBA
- 3
3. If issue persists, replace MEMS PBA due to main PBA wire disconnection code or PBA silver nano part malfunction
This Error Applies To
Samsung WA41A3000A Series Washers (2024) (2024–present)
Related Error Codes
The washer lid is open while it's trying to run
The control boards inside the washer can't communicate
Water is leaking inside the washer
Too much water is in the washer or the water level sensor failed
The laundry load is uneven and the washer can't spin safely
The incoming water is too hot
A button on the washer control panel appears stuck
The washer can't detect the water level properly