Error Code BE
A button on the washer control panel appears stuck
Moderate
Address soon - your appliance may not work properly
Also displayed as: Eco Warm LED flash
What This Means
Power switch or tact switch is continually pressed; Service PBA holding screws fastened too tight; Main PBA switching IC on/off code occurred; Main relay connections incorrect
What actually causes this:
A button got stuck or the screws inside are too tight, pressing against a switch
First Thing to Check
Press each button on the control panel firmly once to try to unstick it
Parts Involved
How to Fix
- 1
1. Check whether either the Power switch or a tact switch is continually pressed
- 2
2. Check whether the service PBA holding screws are fastened too tight — loosen them slightly
- 3
3. Check the contact between the control panel buttons and their corresponding tact switch — there must be a gap between a control panel button and its corresponding micro switch
- 4
4. If the main PBA switching IC on/off code has occurred, replace the main PBA
- 5
5. Check if the Eco Warm LED flashes — if so, check main relay connections. If no issue found, replace the main PBA
This Error Applies To
Samsung WA41A3000A Series Washers (2024) (2024–present)
Related Error Codes
The washer lid is open while it's trying to run
The control boards inside the washer can't communicate
Water is leaking inside the washer
Too much water is in the washer or the water level sensor failed
The laundry load is uneven and the washer can't spin safely
The incoming water is too hot
The washer can't detect the water level properly
The washer isn't filling with water