Error Code DC
The washer lid is open while it's trying to run
Moderate
Address soon - your appliance may not work properly
Also displayed as: Hot LED flash
What This Means
Door/lid not fully closed; Door switch defective; Main PBA door detection circuit defective; Power cord disconnected or insulation issue
What actually causes this:
The lid wasn't closed all the way, or the lid switch isn't sensing it properly
First Thing to Check
Make sure the lid is fully closed — push it down firmly until it clicks
Parts Involved
How to Fix
- 1
1. Check if a Hot LED flashes during the cycle
- 2
2. Close the door/lid securely
- 3
3. Check if 120V power cord is disconnected or check insulation status and repair if necessary
- 4
4. If the main PBA door detection circuit is defective, replace it
This Error Applies To
Samsung WA41A3000A Series Washers (2024) (2024–present)
Related Error Codes
The control boards inside the washer can't communicate
Water is leaking inside the washer
Too much water is in the washer or the water level sensor failed
The laundry load is uneven and the washer can't spin safely
The incoming water is too hot
A button on the washer control panel appears stuck
The washer can't detect the water level properly
The washer isn't filling with water