Error Code DC2
The door lock switch overheated from too many power cycles.
Moderate
Address soon - your appliance may not work properly
Also displayed as: DC2
What This Means
Power switch turned on/off continually generating too much heat; This check is difficult to reproduce
What actually causes this:
The washer was turned on and off many times rapidly, causing the door lock circuit to overheat.
First Thing to Check
Unplug the washer and let it sit for 30 minutes to cool down, then try again.
Parts Involved
How to Fix
- 1
1. Check the door lock switch for signs of overheating
- 2
2. Check the power on/off cycle frequency
- 3
3. Allow the unit to cool and retry
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WA50K8600A Series Washers (2016) (2016–present)
Related Error Codes
The washer's temperature sensor is giving wrong readings.
The washer has detected a water leak.
A specific internal water leak has been found.
There are too many soap suds in the washer.
The washer's vibration sensor board has a problem.
The washer's vibration sensor has a data error.
The washer's vibration sensor board has failed.
The washer cannot determine the clutch position for switching between wash and spin.