Error Code 8C1
The washer's vibration sensor has a data error.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C1
What This Means
MEMS PBA defective; Data error detected on MEMS PBA; Wire connection fault
What actually causes this:
The MEMS vibration sensor board has developed a fault.
First Thing to Check
Unplug the washer for 2 minutes and plug it back in to reset.
Parts Involved
How to Fix
- 1
1. Check the wire connections
- 2
2. Replace the MEMS PBA if necessary
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WA50K8600A Series Washers (2016) (2016–present)
Related Error Codes
The washer cannot detect how much water is in the tub.
The washer's motor cannot spin or is getting bad signals.
The washer is getting too much electrical power.
The washer is not filling with water properly.
The incoming water is too hot for the selected wash cycle.
The washer cannot pump the water out.
The washer is not getting enough electrical power.
The washer's control boards cannot talk to each other.