Error Code dC
The washer lid is not closing or locking properly.
Moderate
Address soon - your appliance may not work properly
Also displayed as: dC
What This Means
Switch contact check due to deformation of the door hook; Door pulled by force; Door lock switch terminal connected incorrectly; Door lock switch terminal is broken; Intermittent electric wire leakage; Main PCB fault
What actually causes this:
The lid is not fully closed, something is caught in the lid, or the lid lock mechanism is worn out.
First Thing to Check
Open the lid, remove any items caught in the way, and close it firmly until you hear it click.
Parts Involved
How to Fix
- 1
1. Close the door — this error occurs because the door is opened
- 2
2. Press the power key to off display and remove the power cord from the outlet
- 3
3. Check the disconnection of the wire at PBA CN801 No23 & No24
- 4
4. Check the door lock switch connector
- 5
5. Door Close: Resistance approx. 0.2 ohm
- 6
6. Door Open: Resistance infinity
- 7
7. If the main PCB is defective, replace it
This Error Applies To
Samsung WA51A5505A Series Washers (2024) (2024–present)
Related Error Codes
The drying heater has an electrical problem.
The washer has detected a water leak somewhere in the system.
An internal circuit board is not communicating properly.
The washer's clutch moved but did not reach the correct position.
The washer's main computer chip has malfunctioned.
The washer's main computer chip has malfunctioned.
The washer's main computer chip has malfunctioned.
The laundry load is uneven and the washer cannot spin safely.