Error Code 8C
The washer's vibration sensor detected a problem
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C
What This Means
Excessive vibration detected by MEMS sensor; MEMS sensor fault; Main PCB fault
What actually causes this:
The washer is not level on the floor, causing excessive shaking during spin cycles
First Thing to Check
Check that all four feet of the washer are firmly on the floor and the unit does not rock
Parts Involved
How to Fix
- 1
1. Check unit for excessive vibration
- 2
2. Verify the washer is properly leveled
- 3
3. Replace Main PCB if vibration is not the cause
This Error Applies To
Samsung WD53DBA900HZA1 Series Washers (2024) (2024–present)
Related Error Codes
A dryer button is being registered as stuck or continuously pressed
The heat pump compressor motor has failed or lost its connection
A temperature sensor on the refrigerant line is reading incorrectly
A temperature sensor on the evaporator inlet is reading incorrectly
A temperature sensor on the evaporator outlet is reading incorrectly
A temperature sensor on top of the compressor is reading incorrectly
The dryer heater temperature sensor is reading incorrectly
The humidity sensor inside the dryer is not reading correctly