Error Code NC
The dryer lint filter is not in place or not being detected
Moderate
Address soon - your appliance may not work properly
Also displayed as: NC
What This Means
Filter switch connected incorrectly; Filter not inserted correctly; Magnet inside the dryer filter not detected; PBA defect
What actually causes this:
The lint filter was removed for cleaning and not put back in, or is not fully seated
First Thing to Check
Open the dryer filter compartment and make sure the lint filter is fully inserted and seated
Parts Involved
How to Fix
- 1
1. Check if the filter is inserted correctly
- 2
2. Tap Start to restart the washer
- 3
3. Or turn it off and on again after 2-3 minutes, then try again
- 4
4. Insert the dryer filter and operate it
- 5
5. Check if there is a magnet inside the dryer filter
- 6
6. If the problem remains unresolved, it may be a PBA defect
This Error Applies To
Samsung WD53DBA900HZA1 Series Washers (2024) (2024–present)
Related Error Codes
The humidity sensor inside the dryer is not reading correctly
The automatic door-opening feature is not working after a cycle ends
A dryer button is being registered as stuck or continuously pressed
The heat pump compressor motor has failed or lost its connection
A temperature sensor on the refrigerant line is reading incorrectly
A temperature sensor on the evaporator inlet is reading incorrectly
A temperature sensor on the evaporator outlet is reading incorrectly
A temperature sensor on top of the compressor is reading incorrectly