Error Code ULC
Soap foam has carried over into the dryer section of the machine
Moderate
Address soon - your appliance may not work properly
Also displayed as: ULC
What This Means
Foam detected during dehumidification course; Water on touch sensor inside the dryer; Magnetic substance attached to touch sensor inside the dryer; PBA defect
What actually causes this:
Too much detergent was used in the wash, and suds carried over into the drying phase
First Thing to Check
Run a rinse-only cycle first to clear out any remaining suds, then try drying again
Parts Involved
How to Fix
- 1
1. Remove the foam inside the dryer and run the dehumidification course
- 2
2. Check if there is water or a magnetic substance attached to the touch sensor inside the dryer and remove it if present
- 3
3. If the problem remains unresolved, it may be a PBA defect
This Error Applies To
Samsung WD53DBA900HZA1 Series Washers (2024) (2024–present)
Related Error Codes
The humidity sensor inside the dryer is not reading correctly
The automatic door-opening feature is not working after a cycle ends
A dryer button is being registered as stuck or continuously pressed
The heat pump compressor motor has failed or lost its connection
A temperature sensor on the refrigerant line is reading incorrectly
A temperature sensor on the evaporator inlet is reading incorrectly
A temperature sensor on the evaporator outlet is reading incorrectly
A temperature sensor on top of the compressor is reading incorrectly