Error Code DC1
The door lock mechanism is not engaging properly
Moderate
Address soon - your appliance may not work properly
Also displayed as: DC1
What This Means
Door lock switch terminal connected incorrectly; Door lock switch terminal broken; Intermittent electric wire leakage; Main PCB fault
What actually causes this:
The door latch mechanism is worn out or the wiring to it is damaged
First Thing to Check
Try closing the door firmly — if you don't hear the lock click, the latch may be broken
Parts Involved
How to Fix
- 1
1. Check the door lock switch terminal connections
- 2
2. Measure door switch resistance — pins 2 and 3 should be approximately 60-90 Ohm (when slider is pushed)
- 3
3. Check for damaged or frayed wires causing leakage
- 4
4. Check main PBA door sensing circuit
- 5
5. Replace door lock switch or main PBA if faulty
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WF45A6400A Series Washers (2024) (2024–present)
Related Error Codes
A button on the control panel is stuck or pressed in
The washer thinks the door is open
The small add-door on the front of the washer is open
The small add-door lock motor is not working correctly
The water heater inside the washer is not working right or the washer is overheating
The washer overheated and shut itself off for safety
The washer is filling with too much water and cannot stop
The washer is not filling with water