Error Code DC
The washer does not detect that the door is closed
Moderate
Address soon - your appliance may not work properly
Also displayed as: DC
What This Means
Door switch fault; Main PCB door sensing circuit fault; Door not fully closed; Laundry caught in the door; Door switch wiring fault
What actually causes this:
The door was not pushed shut firmly, or a piece of clothing is caught in the door seal
First Thing to Check
Make sure nothing is caught in the door, close it firmly, and try again
Parts Involved
How to Fix
- 1
1. Verify the door is fully closed and no laundry is caught in the seal
- 2
2. If a DC error occurs, check whether it occurs during the Boil cycle
- 3
3. Check the door switch resistance — pins 1 and 3 should read approximately 175 ohms
- 4
4. Check and repair the power wire connections and insulation state (120V is directly connected to the door)
- 5
5. If the door switch is faulty, replace it
- 6
6. Check the main PBA door sensing circuit — replace if faulty
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
This Error Applies To
Samsung WF53BB8900 Series Washers (2024) (2024–present)
Related Error Codes
The washer's main control board and display board are not communicating
The main control board and motor driver board stopped talking to each other
The door lock mechanism is not engaging or releasing properly
The add-door lock mechanism has failed
The water heater or temperature sensor is not working correctly
The washer detected a water leak from the drain line
The clothes inside the washer are bunched up on one side
A very heavy or stiff item is causing the drum to be unbalanced