Error Code bC2
A button on the control panel is stuck or being pressed too long
Moderate
Address soon - your appliance may not work properly
Also displayed as: bC2
What This Means
Power button is pressed continually for more than 12 seconds; A switch is jammed or stuck due to being pressed unevenly because of deformation of the control panel or button; Screws that hold the sub PBA in place are tightened too much; A button other than Power is continually pressed for more than 30 seconds; Deformation of an internal plastic injection part; A screw for assembling the sub PBA is tightened too much
What actually causes this:
A button on the control panel is physically stuck, or the screws inside are too tight and pushing against the circuit board
First Thing to Check
Check if any button on the control panel feels stuck — press each button to see if they all spring back freely
Parts Involved
How to Fix
- 1
1. Check if any button is physically stuck or jammed
- 2
2. Inspect the control panel for deformation or warping
- 3
3. Check if the sub PBA mounting screws are over-tightened — loosen slightly if needed
- 4
4. Check for deformed internal plastic parts pressing against buttons
- 5
5. If the issue persists, replace the control panel assembly
This Error Applies To
Samsung WF56H9100A Series Washers (2018) (2018–present)
Related Error Codes
The small Add Door on top of the main door is open
An internal electronic module cannot communicate with the main board
The WiFi module cannot communicate with the main board
The display screen cannot communicate with the main board
The motor speed controller cannot communicate with the main board
The vibration sensor board has a fault
The washer's main computer chip has stopped working
The washer's main computer chip has stopped working