How do I fix error code LC on a Samsung washers?

1. undefined: 1. Check for any leakage on the base, Hose, Valve, and Tub connections 2. undefined: 2. Check whether there is any foreign material in the bellows (drain bellows are clogged with foreign material such as underwire or coins) 3. undefined: 3. Check the drain motor operation — if it does not operate normally, check and replace 4. undefined: 4. Remove the foreign material from the drain area 5. undefined: 5. If incorrect part engagement or omitted rubber packaging, replace or re-engage correctly 6. undefined: 6. Check all hose connections and tub screws for proper fastening 7. undefined: 7. Check the leakage sensor itself for faults

Samsung Washers2018–present

Error Code LC

Q: What does error code LC mean on a Samsung washers?

Water is leaking inside the washer where it should not be Air hose is out of place and water leakage occurs during the spin cycle; Tub back at the safety bolts fixing part is broken; Water leakage at the front due to too much detergent causing foaming; Connecting hose to the detergent drawer is connected incorrectly; Drain pump filter cover is engaged incorrectly; Water leakage at the drain hose; Duct condensing holding screws are worn; Nozzle-diaphragm is engaged in the opposite direction or rubber packaging is omitted; Water leakage because screws holding tub back and front are fastened incorrectly; Leakage sensor is faulty

Water is leaking inside the washer where it should not be

Critical

Stop using immediately - risk of damage or safety issue

Also displayed as: LC

What This Means

Air hose is out of place and water leakage occurs during the spin cycle; Tub back at the safety bolts fixing part is broken; Water leakage at the front due to too much detergent causing foaming; Connecting hose to the detergent drawer is connected incorrectly; Drain pump filter cover is engaged incorrectly; Water leakage at the drain hose; Duct condensing holding screws are worn; Nozzle-diaphragm is engaged in the opposite direction or rubber packaging is omitted; Water leakage because screws holding tub back and front are fastened incorrectly; Leakage sensor is faulty

What actually causes this:

Too much detergent caused excessive suds that leaked past the door seal, or a hose connection came loose inside the machine

First Thing to Check

Unplug the washer immediately and check for water on the floor — use less detergent in your next load

Parts Involved

Leakage SensorAir HoseDrain HoseDrain Pump Filter CoverDiaphragmTub Assembly

How to Fix

1
1. Check for any leakage on the base, Hose, Valve, and Tub connections
2
2. Check whether there is any foreign material in the bellows (drain bellows are clogged with foreign material such as underwire or coins)
3
3. Check the drain motor operation — if it does not operate normally, check and replace
4
4. Remove the foreign material from the drain area
5
5. If incorrect part engagement or omitted rubber packaging, replace or re-engage correctly
6
6. Check all hose connections and tub screws for proper fastening
7
7. Check the leakage sensor itself for faults