Error Code 8E
An internal vibration sensor has stopped working
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8E
What This Means
MEMS sensor output voltage out of range (>4.5V or <0.5V); MEMS PBA defective; Wire connector terminals disconnected
What actually causes this:
The vibration sensor board wiring came loose or the sensor failed
First Thing to Check
Unplug the washer for a few minutes and try again
Parts Involved
How to Fix
- 1
1. Check MEMS sensor and PBA
- 2
2. Check wire connector terminals
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for WA456DRHDSU
The washer can't detect the water level properly
The washer's motor isn't working
A button on the washer control panel appears stuck
The washer lid detected an opening while trying to start
The washer door won't unlock after the cycle finishes
The washer lid won't lock
Water is leaking inside the washer
Too much water is in the washer