Error Code 8C2
The vibration sensor board is not working
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C2
What This Means
MEMS PBA is defective; Main PBA wire disconnection
What actually causes this:
The wire between the main control board and the vibration sensor has come disconnected
First Thing to Check
Turn off the washer, wait a few minutes, and restart — if the error returns, it needs service
Parts Involved
How to Fix
- 1
1. Check MEMS PBA connections
- 2
2. Replace MEMS PBA because of Main PBA wire disconnection
Other Error Codes for WA45T3200AW
The water inside the washer is dangerously hot
The washer cannot detect where the clutch is positioned
The vibration sensor board is not working
The water level sensor cannot detect the water level
The washer's motor is not spinning properly
The power supply voltage is too high
The power supply voltage is too low
The clutch sensor signal dropped out during operation