Error Code dC1
The washer door cannot lock properly
Moderate
Address soon - your appliance may not work properly
Also displayed as: dC1
What This Means
Door lock switch unit is not inserted; Door lock switch unit is damaged; Wire is disconnected; Door lock switch unit is defective; Main PCB is defective
What actually causes this:
The door lock mechanism is jammed or the lock switch has failed
First Thing to Check
Try opening and closing the lid a few times firmly — sometimes the lock mechanism just needs to be reset
Parts Involved
How to Fix
- 1
1. Check whether the door lock switch unit is inserted
- 2
2. Check whether the door lock switch unit is damaged
- 3
3. Check the disconnection of the wire
- 4
4. Check the resistance for Lock motor (black-brown wire) — should be 33 to 46 ohms between terminals
- 5
5. Check the resistance for Lock contact (white-red wire) — should be approximately 0.2 ohms between terminals
- 6
6. Check the resistance for Unlock contact (white-blue wire) — should be approximately 0.2 ohms between terminals
- 7
7. Check the Door Lock and Unlock state
- 8
8. If the door lock switch unit is defective, replace it
- 9
9. If the main PCB is defective, replace it
Other Error Codes for WA45T3200AW
The water inside the washer is dangerously hot
The washer cannot detect where the clutch is positioned
The vibration sensor board is not working
The vibration sensor board is not working
The water level sensor cannot detect the water level
The washer's motor is not spinning properly
The power supply voltage is too high
The power supply voltage is too low