Error Code dC2
The washer door is stuck locked and cannot open
Moderate
Address soon - your appliance may not work properly
Also displayed as: dC2
What This Means
Door lock switch unit is not inserted; Door lock switch unit is damaged; Wire is disconnected; Door lock switch unit is defective; Main PCB is defective
What actually causes this:
The door lock mechanism has jammed in the locked position or the unlock circuit has failed
First Thing to Check
Unplug the washer for 5 minutes, then plug it back in and try to open the lid
Parts Involved
How to Fix
- 1
1. Check whether the door lock switch unit is inserted
- 2
2. Check whether the door lock switch unit is damaged
- 3
3. Check the disconnection of the wire
- 4
4. Check the resistance for Lock motor (black-brown wire) — should be 33 to 46 ohms between terminals
- 5
5. Check the resistance for Lock contact (white-red wire) — should be approximately 0.2 ohms between terminals
- 6
6. Check the resistance for Unlock contact (white-blue wire) — should be approximately 0.2 ohms between terminals
- 7
7. Check the Door Lock and Unlock state
- 8
8. If the door lock switch unit is defective, replace it
- 9
9. If the main PCB is defective, replace it
Other Error Codes for WA45T3200AW
The water inside the washer is dangerously hot
The washer cannot detect where the clutch is positioned
The vibration sensor board is not working
The vibration sensor board is not working
The water level sensor cannot detect the water level
The washer's motor is not spinning properly
The power supply voltage is too high
The power supply voltage is too low