Error Code BC2
The washer thinks a button is stuck or a control circuit has failed.
Moderate
Address soon - your appliance may not work properly
Also displayed as: BC2
What This Means
Power button continually pressed or stuck; Another button continually pressed or stuck; Service PBA holding screws fastened too tight; Main PBA switching IC on/off malfunction; Main relay connections incorrect
What actually causes this:
Usually a button on the control panel is physically stuck or the circuit board screws are too tight, pushing a button contact closed.
First Thing to Check
Check if any buttons on the control panel feel stuck or are not springing back when pressed.
Parts Involved
How to Fix
- 1
1. Check if the Power switch or a tact switch is continually pressed — there must be a gap between a control panel button and its corresponding micro switch
- 2
2. Check whether the service PBA holding screws are fastened too tight; if so, loosen them slightly
- 3
3. Check occurs after approximately 30 seconds of continuous press
- 4
4. If the main PBA switching IC on/off has occurred, replace the main PBA
- 5
5. The E2 check occurs if the main relay connections are incorrect — check connections and replace main PBA if needed
Other Error Codes for WA46CG3505AVA4
The vibration sensor that helps keep the washer balanced is not working.
The vibration sensor board is not communicating properly.
The washer is not getting enough voltage from the electrical outlet.
The washer detected a problem with the water heating system.
The washer detected a problem with the water heating system.
The clutch sensor is sending the wrong signal to the control board.
The temperature sensor for the wash water is giving bad readings.
A temperature sensor related to the condensing system is malfunctioning.