Error Code 4C
Your washer is not getting enough water to run the cycle.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4C
What This Means
Foreign material in the water supply valve; Water supply valve terminal not connected or wire disconnected; Warm water and rinse connectors swapped; PCB terminal from drain hose to detergent drawer not connected; Transparent hose is folded or torn; Water supply hoses are kinked restricting water flow; Cold and warm water supply hoses swapped; Water supply valve is defective; Main PBA relay malfunction; Water is frozen in supply lines
What actually causes this:
Usually the water supply faucets are turned off or the inlet hoses are kinked.
First Thing to Check
Make sure both hot and cold water faucets behind the washer are fully turned on.
Parts Involved
How to Fix
- 1
1. Check if water supply is blocked due to frozen water
- 2
2. Make sure cold water tap and hot water tap are properly connected at both the tap and the machine
- 3
3. Check for foreign material in the water supply valve filter
- 4
4. Measure the resistance of the water supply valve: 0.9K ohms to 1.1K ohms between terminals
- 5
5. If the water supply valve is broken, replace the valve
- 6
6. If the PBA relay malfunctions, replace the PBA
Other Error Codes for WA50R5200AW
Your washer cannot detect how much water is in the tub.
A vibration sensor wire has come loose inside the washer.
The washer's WiFi module has lost its connection to the main board.
Your washer's door lock mechanism is not working correctly.
Your washer is filling with too much water and cannot detect when to stop.
Your washer has detected a water leak.
An internal power module in the washer is overheating.
Your washer's vibration sensor is not communicating properly.