Error Code Sr
An internal relay switch inside your washer has failed.
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: Sr
What This Means
Main relay of the PBA is short-circuited; Main relay terminal is connected incorrectly; Terminal is bent and contact cannot be made; Main PCB relay fault
What actually causes this:
An electrical component on the main control board has failed or shorted out.
First Thing to Check
Unplug the washer for 60 seconds, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Check if the main PBA switching IC on/off button and its micro switch — if an error has occurred, replace the main PBA
- 2
2. Check the connections — if no error in connections, replace the main PBA
- 3
3. Check for main relay fault on PCB
Other Error Codes for WF42H5000AW
Your washer's motor cannot spin the drum.
The control boards inside your washer are not communicating.
Your washer is not getting enough water.
Your washer lost power briefly during a cycle.
A button on your washer's control panel appears stuck.
Your washer detected a problem with its water heating system.
Your washer thinks the door is not closing properly.
Your washer is overfilling with water.