Error Code 9C2
Your washer is getting too much electrical power from the outlet.
Critical
Stop using immediately - risk of damage or safety issue
Also displayed as: 9C2
What This Means
Over voltage from the power supply; Unstable consumer power conditions; Main PBA fault
What actually causes this:
The electrical supply in your home may be experiencing power surges or unusually high voltage.
First Thing to Check
Unplug the washer for 60 seconds, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Check the consumer's power conditions by measuring the operating voltage at the wall outlet
- 2
2. Connect a tester to the internal power terminals and verify voltage is within acceptable range
- 3
3. Check if the home's electrical supply is experiencing surges
- 4
4. If voltage is stable and error persists, suspect main PBA fault
Parts Commonly Needed for This Error
OEM part numbers confirmed by retailers
Other Error Codes for WF45N5300AF
The small add-door on the front of your washer is not properly closed or locked.
Your washer has detected a water leak inside the machine.
Your washer's vibration sensor has a general fault.
Your washer's main computer board has crashed and cannot recover.
An internal communication module in your washer has lost its connection.
Your washer's door lock mechanism has a hardware fault.
Your washer's motor controller has lost communication with the main board.
Your washer is not getting enough water to start or continue the cycle.