Error Code 4C2
The water coming into your washer is too hot for the selected cycle.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 4C2
What This Means
Cold and warm water supply hoses are wrongly connected to each other; Water temperature sensed as higher than 50 degrees C in the Wool or Lingerie courses
What actually causes this:
The hot and cold water hoses behind the washer are probably connected to the wrong faucets, so hot water goes where cold water should.
First Thing to Check
Check the hoses behind the washer — make sure the hot hose goes to the hot faucet and the cold hose goes to the cold faucet.
Parts Involved
How to Fix
- 1
1. Check that the hot water hose is connected to the hot water inlet and the cold water hose to the cold water inlet
- 2
2. Verify incoming water temperature is below 50 degrees C for delicate cycles
- 3
3. Run a test fill and measure the water temperature entering the machine
Other Error Codes for WF45N5300AW
An internal communication module in your washer has lost its connection.
Your washer's vibration sensor has a general fault.
Your washer's main computer board has crashed and cannot recover.
Your washer's door lock mechanism has a hardware fault.
Your washer's motor controller has lost communication with the main board.
Your washer is not getting enough water to start or continue the cycle.
Your washer is not getting enough electrical power to run properly.
Your washer cannot detect the water level inside the drum.