Error Code 8C
Your washer's vibration sensor has a general fault.
Moderate
Address soon - your appliance may not work properly
Also displayed as: 8C
What This Means
Wire connections to MEMS PBA disconnected or loose; MEMS PBA hardware fault
What actually causes this:
The vibration-sensing board inside the washer has either come loose or stopped working.
First Thing to Check
Unplug the washer for 2 minutes, then plug it back in and try again.
Parts Involved
How to Fix
- 1
1. Check the wire connections to the MEMS PBA
- 2
2. Replace the MEMS PBA if connections are good but error persists
Other Error Codes for WF45N5300AW
An internal communication module in your washer has lost its connection.
Your washer's main computer board has crashed and cannot recover.
Your washer's door lock mechanism has a hardware fault.
Your washer's motor controller has lost communication with the main board.
Your washer is not getting enough water to start or continue the cycle.
Your washer is not getting enough electrical power to run properly.
Your washer cannot detect the water level inside the drum.
The water coming into your washer is too hot for the selected cycle.